Inactive state的UE會透過以下三個事件觸發RNAU(RAN-based Notification Area Update):
- 事件一: Periodic RNAU timer expired
- 當Periodic RNAU timer(i.e. T380 timer)到期時。
- 事件二: Previous barred RNAU is alleviated
- 此事件的觸發條件包含以下條件:
- barring is alleviated for Access Category '8‘ (i.e., RNAU的Access Category)
- 上層沒有要觸發Resume procedure
- pendingRnaUpdate參數被設為true
- 事件三:UE moves out of the configured RNA
- 當UE移動到新的cell,判斷為此cell不屬於RNA時。
當Inactive state的UE觸發RNAU後,根據接收gNB不同的回應會有不同的狀態轉移。
- 狀態轉移一: 回到Connected state
- 進到Connected state是因為UE觸發RNAU後,可能收到RRC resume message代表Resume成功或是收到RRC setup message代表網路希望UE重新建立連線。
- 狀態轉移二: 回到Idle state
- 進到Idle state是因為UE收到RRC release message其中不包含suspendConfig,可能代表網路正發生Overloading的狀態,所以無法服務UE。
- 狀態轉移三: 回到Inactive state
- 進到Inactive state是可能是收到RRC release message其中包含suspendConfig,此時UE應該根據suspendConfig的參數,重新configure關於Inactive state的參數,然後再進入Inactive state。
- 另一種情況,可能是UE收到RRC reject message(或是RRC release message)其中包含wait timer。則UE應該在wait timer time out之後,再次執行Resume procedure。而在wait timer期間,UE都繼續留在Inactive state。